Activity

HDPE waterproofing membrane products execute a good job of keeping the house dry and tidy, it’s one of several good solutions for leaking houses since it is affordable, it’s low maintenance, and it’s very convenient.

Whether it’s a leaking roof or perhaps a room leaking to another level of occupants, it may cause property damage in addition to neighborhoods. This can be a ubiquitous architectural phenomenon, along with construction, leaking water could be the second biggest problem in building quality. Now, many individuals have got measures, waterproof coatings, waterproof membranes, along with other products.

Precisely what are HDPE damp membranes?

HDPE damp membranes are actually a self-adhesive waterproof material, which has the characteristics of superior performance, warm resistance, and durability. Additionally, the self-adhesive film features a polymer adhesive layer.

HDPE damp membranes are constructed with high-quality high-density polyethylene resin, and at the same time frame, ultraviolet absorbers, anti-aging agents, etc. are also used.

Popular features of HDPE waterproof membrane

Durable

Long-lasting

Less maintenance

Supports construction on wet bases

Easy to construct

Castable skeleton steel bar

It might form a super-strong bond with concrete, thus preventing the penetration of rain and moisture

Ready to walk

Following the waterproof layer is fully gone, it can be directly associated with the outcome resistance of reinforced concrete with no protective layer

Low requirements to the base layer, and is constructed on uneven and wet base surfaces

Not affected by objective factors, thereby reducing construction costs

More flexible construction methods

Good waterproof performance

Widely application

Whether it be the roof section of the ramp, the waterproofing of the tunnel, along with the pool, it is usually perfectly waterproofed. Concurrently, HDPE damp membranes can be used high-requirement waterproof projects plus some gas leakage prevention.

Installation tips

Keep the base layer clean first. When the sharp area of the protrusion can be found, it’ll be processed to be flat. Should there be more water stains, keep your lower layer moist.

Unroll the membrane. When laying the show on the base layer, you need to take note of the particles in the film facing up, and the edges present in adjacent films must be aligned in order to avoid overlapping.

How to determine the thickness with the film meets certain requirements?

This method is very brief, have a needle and randomly select 3 points per 100 square meters for the membrane for penetration experiments. Dimensional measurements were created for that thickness with the 3 needle punches respectively, lastly, the average value was taken for heights. If the average thickness is larger than 1.5mm, it meets certain requirements.

For more information about màng hdpe go to see our website